NoticeTranslations:ITDB02-2.8/11/en
From ITEAD Wiki
| Pin | Type* | Description |
| GND | G | Ground |
| VCC | P | 5V Power Supply pin |
| NC | - | No connection |
| RS | I | Data/Command selection |
| WR | I | Write signal enable, low active |
| RD | I | Read signal enable, low active |
| DB8 | I | Data Bus |
| DB9 | I | Data Bus |
| DB10 | I | Data Bus |
| DB11 | I | Data Bus |
| DB12 | I | Data Bus |
| DB13 | I | Data Bus |
| DB14 | I | Data Bus |
| DB15 | I | Data Bus |
| CS | I | Chip Selection，Low level active |
| NC | - | No connection |
| LED | P | Backlight |
| NC | - | No connection |
| DB0 | - | No connection(8bit and 16bit mode) |
| DB1 | - | No connection(8bit and 16bit mode) |
| DB2 | - | No connection(8bit and 16bit mode) |
| DB3 | - | No connection(8bit and 16bit mode) |
| DB4 | - | No connection(8bit and 16bit mode) |
| DB5 | - | No connection(8bit and 16bit mode) |
| DB6 | - | No connection(8bit and 16bit mode) |
| DB7 | - | No connection(8bit and 16bit mode) |
| T_CLK | I | Touch clock |
| T_CS | I | Touch chip selection |
| T_DIN | I | Touch data input |
| T_BUSY | O | Touch status |
| T_DOUT | O | Touch data output |
| T_IRQ | O | Touch interrupt |
| SD_SO | O | SD MISO |
| SD_SCK | I | SD SCK |
| SD_SI | I | SD MOSI |
| SD_NSS | I | SD NSS |
| NC | - | No connection |
| NC | - | No connection |
