Translations:ITDB02-2.8/11/en

From ITEAD Wiki
Jump to: navigation, search
Pin Type* Description
GND G Ground
VCC P 5V Power Supply pin
NC - No connection
RS I Data/Command selection
WR I Write signal enable, low active
RD I Read signal enable, low active
DB8 I Data Bus
DB9 I Data Bus
DB10 I Data Bus
DB11 I Data Bus
DB12 I Data Bus
DB13 I Data Bus
DB14 I Data Bus
DB15 I Data Bus
CS I Chip Selection,Low level active
NC - No connection
LED P Backlight
NC - No connection
DB0 - No connection(8bit and 16bit mode)
DB1 - No connection(8bit and 16bit mode)
DB2 - No connection(8bit and 16bit mode)
DB3 - No connection(8bit and 16bit mode)
DB4 - No connection(8bit and 16bit mode)
DB5 - No connection(8bit and 16bit mode)
DB6 - No connection(8bit and 16bit mode)
DB7 - No connection(8bit and 16bit mode)
T_CLK I Touch clock
T_CS I Touch chip selection
T_DIN I Touch data input
T_BUSY O Touch status
T_DOUT O Touch data output
T_IRQ O Touch interrupt
SD_SO O SD MISO
SD_SCK I SD SCK
SD_SI I SD MOSI
SD_NSS I SD NSS
NC - No connection
NC - No connection