ITEAD Joystick shield

Overview

The Joystick Shield kit contains all the parts you need to enable your Arduino with a joystick! The shield sits on top of your Arduino and turns it into a simple controller. Five momentary push buttons (4+ joystick select button) and a two-axis thumb joystick gives your Arduino functionality on the level of old Nintendo controllers.

The momentary push buttons are connected to Arduino digital pins 2-6; when pressed they will pull the pin low (utilizing the internal pull-ups of the Arduino). Vertical movement of the joystick will produce a proportional analog voltage on analog pin 0, likewise, horizontal movement of the joystick can be tracked on analog pin 1.

Specifications

PCB size	53.3mm X 68.6mm X 1.6mm
Power supply	5V/3.3V DC
RoSH	Yes

Electrical Characteristics

Parameter	Min.	Typical	Max.	Unit
Power voltage	3	5	5.5	VDC
Input voltage VH (Target Voltage = 3.3V)	3	3.3	3.6	V
Input voltage VH (Target Voltage = 5V)	4.5	5	5.5	V
Input voltage VL	-0.3	0	0.5	V
Current Consumption	-	20	40	mA

Hardware

Pins description

Pin	Output type	Description
D0	NA	No Connection
D1	NA	No Connection
D2	NA	No Connection
D3	Digital	Button E Output
D4	Digital	Button D Output
D5	Digital	Button C Output
D6	Digital	Button B Output
D7	Digital	Button A Output
D8	Digital	Button F Output
D9	Digital	Button G Output
D10	NA	No Connection
D11	NA	No Connection
D12	NA	No Connection
D13	NA	No Connection
A0	Analog	Joystick Y Ouput
A1	Analog	Joystick X Ouput
A2	NA	No Connection
A3	NA	No Connection
A4	NA	No Connection
A5	NA	No Connection

Jumper description

Switch	Description
+3.3V	Work with 3.3V system, like IFLAT32, Iteadmaple
+5V	Work with 5V system, like Arduino, Iteaduino

Pin map description

VCC	B OUTPUT	A OUTPUT	Y OUTPUT	X OUTPUT	GND
GND	C OUTPUT	D OUTPUT	E OUTPUT	F OUTPUT	G OUTPUT