NoticeDifference between revisions of "NA-01 POE enabled UART to Ethernet Converter"
From ITEAD Wiki
m (→Electrical Characteristics) |
m (→Interface Functions) |
||
| Line 29: | Line 29: | ||
==Interface Functions== | ==Interface Functions== | ||
| + | GPIO | ||
| + | *VCC: 5V power supply | ||
| + | *RXD: Data in pin of serial port | ||
| + | *TXD: Data out pin of serial port | ||
| + | *RTS: Can be used as RS485 enable pin | ||
| + | *CTS: Can be used as a network connection status indicator pin | ||
| + | Button | ||
| + | *RST: RESET. Press 200ms low to reset the whole module | ||
| + | *ISP: Update.Press the button to upgrade the firmware. | ||
| + | *CFG: Configuration. Used for module configuration. Same as the CFG jummper. | ||
==Voltage Level== | ==Voltage Level== | ||
==Useful Link== | ==Useful Link== | ||
Revision as of 07:27, 7 April 2016
Contents
Overview
The NA-01 is a multi-functional embedded Ethernet serial data conversion module. The module internally integrated TCP/ IP protocol stack, allowing users easily use it to build network for embedded devices, thus helps saving manpower and development time, putting the products on the market in short time. The module integrated 10/100M self-adaption Ethernet interface, the serial communication maximum baudrate is up to 230.4Kbps, providing TCP Server, TCP Client, UDP working mode, easily configurable by software, IEEE802.3af standard compliant, POE power supply supported.
Go shopping NA01-POE Enabled UART to Ethernet Converter (IM160307001)
Specification
| PCB_size | col80mm_X_60mm_X_20mm |
|---|---|
| Power supply | POE |
| Interface | UART, Ethernet interface |
Electrical Characteristics
| Parameter | Min | Typical | Max | Unit |
|---|---|---|---|---|
| Input voltage（VCC） | 42 | 48 | 55 | VDC |
| Input voltage VinH | 3 | 3.3 | 3.6 | V |
| Input voltage VinL | -0.3 | 0 | 0.5 | V |
| Baud rate | 9600 | bps |
Hardware
Interface Functions
GPIO
- VCC: 5V power supply
- RXD: Data in pin of serial port
- TXD: Data out pin of serial port
- RTS: Can be used as RS485 enable pin
- CTS: Can be used as a network connection status indicator pin
Button
- RST: RESET. Press 200ms low to reset the whole module
- ISP: Update.Press the button to upgrade the firmware.
- CFG: Configuration. Used for module configuration. Same as the CFG jummper.
