Difference between revisions of "Wee Serial WIFI Module"

From ITEAD Wiki
Jump to: navigation, search
(Created page with "==Overview== Wee is a WIFI module based on ESP8266 SoC. ESP8266 comes out of nowhere and has been taking by storm the IoT world. You can find many hacking projects about it on...")
(No difference)

Revision as of 06:48, 10 December 2014

Overview

Wee is a WIFI module based on ESP8266 SoC. ESP8266 comes out of nowhere and has been taking by storm the IoT world. You can find many hacking projects about it on the internet. So far, the most popular ESP8266 breakout version only has GPIO0 and GPIO2 routed to the header. Compared to it, Wee WIFI module is designed with a standard Bee interface and has more GPIOs available for developers. In a word, users can take full use of the utility of ESP8266 SoC by using Wee WIFI module in your projects.

Go shopping [Wee Serial WIFI Module]

Features

  • Standard Bee interface
  • indicators: TX, RX, PWR
  • FW/Work Switch – when burn firmware into ESP8266, you should ensure the switch is in FW status. For the normal usage of this module, you should ensure the switch is in work status.
  • More GPIOs help developer take full use of the utility of ESP8266 SoC

Specification

PCB Size 23.9X26.2X1.6mm
Interface Bee interface
Indicators PWR,TX,RX

Electrical Characteristics

Characteristics Symbol Min Typ Max Unit
Power supply voltage VDD 3 3.3 3.5 V
High input voltage VIH 0.8XVDD - VDD V
Low input voltage VIL 0 - 0.2XVDD V
Operation current for VDD IDD - - 215 mA

Hardware

Pin Map

Pin Index Pin Name Description
1 3V3
2 TX
3 RX
4 -
5 RST# Enable wee module to reset in low level
6 -
7 FW Firmware enable pin*
8 -
9 -
10 GND
11 -
12 -
13 -
14 -
15 -
16 -
17 IO4
18 IO3
19 IO2
20 IO1

Note: Firmware enable pin

  • When set to 0, reset the wee module and enable the firmware uploading mode;
  • When set to 1, reset the wee module and enable the normal work mode

Instruction

AT Commands

Download