Difference between revisions of "Translations:ITDB02-2.2S/12/zh-cn"

From ITEAD Wiki
Jump to: navigation, search
(Created page with "用UNO烧写程序。用arduino IDE打开Adafruit_ILI9340中'''spitftbitmap.ino'''。然后ITDB02-2.2S模块电平选择5V，按照以下的接线方式使用杜邦线连...")
 
m
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
−
用UNO烧写程序。用arduino IDE打开Adafruit_ILI9340中'''spitftbitmap.ino'''。然后[[ITDB02-2.2S]]模块电平选择5V，按照以下的接线方式使用杜邦线连接UNO和[[ITDB02-2.2S]]模块：
+
*用arduino IDE打开Adafruit_ILI9340中'''spitftbitmap.ino''',将其烧写进UNO主板。
 +
*[[ITDB02-2.2S]]模块电平选择5V，按照以下的接线方式使用杜邦线连接UNO和[[ITDB02-2.2S]]模块：

Latest revision as of 03:41, 22 July 2014

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (ITDB02-2.2S)
*Use arduino IDE to open '''spitftbitmap.ino''' in the directory '''Adafruit_ILI9340\examples\spitftbitmap''' then upload it to UNO main board. Select 5V electronic level in the 2.2S LCD module, then use dupont lines to connect UNO and LCD module according to the table as below:
Translation*用arduino IDE打开Adafruit_ILI9340中'''spitftbitmap.ino''',将其烧写进UNO主板。
*[[ITDB02-2.2S]]模块电平选择5V，按照以下的接线方式使用杜邦线连接UNO和[[ITDB02-2.2S]]模块：
  • 用arduino IDE打开Adafruit_ILI9340中spitftbitmap.ino,将其烧写进UNO主板。
  • ITDB02-2.2S模块电平选择5V，按照以下的接线方式使用杜邦线连接UNO和ITDB02-2.2S模块：
Retrieved from "https://wiki.iteadstudio.com/index.php?title=Translations:ITDB02-2.2S/12/zh-cn&oldid=2269"