Difference between revisions of "Low-cost Digital Compass Module"

From ITEAD Wiki
Jump to: navigation, search
(Specifications)
(Hardware)
Line 28: Line 28:
  
 
==Hardware ==
 
==Hardware ==
 +
http://imall.iteadstudio.com/media/wysiwyg/Products/Modules/digital_compass_module.jpg
  
 
==Serial Communication Protocol==
 
==Serial Communication Protocol==

Revision as of 09:14, 29 May 2014

Overview

LOW-COST DIGITAL COMPASS MODULE.jpg

This is a low cost digital compass with UART and IIC interface, it's easy to use with external controler like Arduino,IFLAT32.

Features

  • Small size
  • Uart or IIC doulbe output/control interface
  • 3-5V Voltage comaptible

Specifications

Measuring range 0-360 °
Resolution 0.1
Accuracy
Power supply 3V-5V DC
Frequency response 25Hz
Current 5 V--15mA 3V--8 mA
Size 25.6mm×25.6mm

Hardware

digital_compass_module.jpg

Serial Communication Protocol

Baud rate: 9600 bps Parity: N data bits: 8 Stop bit: 1

Command

0x31: the first angle measurement 0xC0: calibration of the magnetic field start 0xC1: the end of the calibration magnetic field 0xA0-0XAA-0XA5-0XC5: Restore default setting 0xA0-0XAA-0XA5-IIC_ADDR: IIC address of the module change 0x03 + 8bit: Setting the magnetic declination high 8 bit 0x04 + 8bit: Setting the magnetic declination low8 bit Return Data

Byte0: 0x0D Byte1: 0x0A Byte2: 0x30 ~ 0x33 angle of one hundred (ASCII 0 ~ 3) Byte3: 0x30 ~ 0x39 angle of ten (ASCII 0 ~ 9) Byte4: 0x30 ~ 0x39 angle a bit (ASCII 0 ~ 9) Byte5: 0x2E (ASCII code decimal point) Byte6: 0x30 ~ 0x39 decimal point (ASCII 0 ~ 9) Byte7: 0x00 ~ 0xFF checksum (only lower 8bit) You can use the Foca or USBtoTLL moudle to connect your PC with this moudle.

IIC Communication Protocol:

Download

Useful Links