NoticeDifference between revisions of "Iteaduino UNO"
From ITEAD Wiki
(→Hardware) |
|||
| Line 43: | Line 43: | ||
==Hardware== | ==Hardware== | ||
[[File:IteadunoUNO1.jpg]] | [[File:IteadunoUNO1.jpg]] | ||
| + | |||
Digital/Servo Interface: D0~D13 pin | Digital/Servo Interface: D0~D13 pin | ||
| + | |||
Sensor Interface: A0 A1 A2 A3 A4 A5 pin | Sensor Interface: A0 A1 A2 A3 A4 A5 pin | ||
Revision as of 01:11, 20 May 2014
Contents
Overview
Iteaduino Uno is a microcontroller board based on the Arduino UNO. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with an AC-to-DC adapter or battery to get started.
Features
- New external IO pin map
- Efficient DC-DC Power supply with wide range input
- 3.3V/5V Operating Voltage selection
- All pins out for Sensor and Servo
- UART/IIC interface breakout
Spec
| Microprocessor | ATmega328,ATmega8U2 |
| PCB size | 68.58mm X 58.42mm X 1.6mm |
| Indicators | Power,TX,RX,D13 |
| Power supply(recommended) | 7-23V DC |
| Power supply(limits) | 23 VDC (max) |
| Communication Protocol | UART,SPI,IIC |
| Clock Speed | 16MHz |
Electrical Characteristics
Hardware
Digital/Servo Interface: D0~D13 pin
Sensor Interface: A0 A1 A2 A3 A4 A5 pin
Pin Map
Power
Memory
Input and Output
Communication
Programming
Automatic (Software) Reset
USB Over-current Protection
Links and References
Download
Fritzing Parts for Iteaduino UNO
