ITDB02-2.4E V1

From ITEAD Wiki
Revision as of 03:18, 22 April 2016 by ITead (Talk | contribs)

Jump to: navigation, search

Overview

ITDB02-2.4E.jpg

ITDB02-2.4E V1 module is 2.4" TFT LCD with 65K color 320 x 240 resolutions. The controller of this LCD module is ILI9325D, it supports 8bit / 16bit data interface with 4 wires control interface. Moreover, this module includes the touch screen and SD card socket.

Go shopping ITDB02-2.4E V1 (IM120419004)

Features

  • 8bits/16bits operation compatible
  • Compatible with UTFT library
  • With SD Card Socket

Specifications

Driver IC ILI9325D
Backlight 4LEDs
Power supply 3V3
Touch Panel Y
Touch IC XPT2046
Resolution 240*320
Size 50mm*65mm

Hardware

IM120419004_ITDB02_2.4E.jpg ITDB02-2.4-parallel.jpg Bottom View

Pin Map list

Pin Type* Description
GND G Ground
VCC P 5V Power Supply pin
NC - No connection
RS I Data/Command selection
WR I Write signal enable, low active
RD I Read signal enable, low active
DB8 I Data Bus
DB9 I Data Bus
DB10 I Data Bus
DB11 I Data Bus
DB12 I Data Bus
DB13 I Data Bus
DB14 I Data Bus
DB15 I Data Bus
CS I Chip Selection,Low level active
NC - No connection
LED P Backlight
NC - No connection
DB0 - No connection(8bit mode)
DB0 I Data Bus(16bit mode)
DB1 - No connection(8bit mode)
DB1 I Data Bus(16bit mode)
DB2 - No connection(8bit mode)
DB2 I Data Bus(16bit mode)
DB3 - No connection(8bit mode)
DB3 I Data Bus(16bit mode)
DB4 - No connection(8bit mode)
DB4 I Data Bus(16bit mode)
DB5 - No connection(8bit mode)
DB5 I Data Bus(16bit mode)
DB6 - No connection(8bit mode)
DB6 I Data Bus(16bit mode)
DB7 - No connection(8bit mode)
DB7 I Data Bus(16bit mode)
T_CLK I Touch clock
T_CS I Touch chip selection
T_DIN I Touch data input
T_BUSY O Touch status
T_DOUT O Touch data output
T_IRQ O Touch interrupt
SD_SO O SD MISO
SD_SCK I SD SCK
SD_SI I SD MOSI
SD_NSS I SD NSS
NC - No connection
NC - No connection

Type *:P: Power supply; G:Ground; I:Input; O:Output;

The ITDB02_2.4E uses the ILI9325D controller , it support 8/16bit data interface. The touch IC is TSC2046.

Installation

When operate in 8 bits mode, the mode switch need to set in 8bits side.

When operate in 16 bits mode, the mode switch need to set in 16bits side.

Download

Datasheet for ITDB02_2.4E

Schematic

Demo code

UTFT library

Useful Links

by Henning Kalsen <UTFT Library>

<Raspberry PI With TFT LCD Demo>