IR Shield

概述

IR Shield是一块Arduino主板的扩展板，它带有红外收发模块，nRF24L01接口，XBee接口，MicroSD卡接口和温湿度传感器。有了它，你就可以监控室内的温湿度和控制红外的设备（空调，电视等等），使你的家变得更加智能化。

Go shopping

- 兼容5/3.3V主板 - micro SD卡接口 - XBee 接口

Specification

PCB size	55.88mm X 68.58mm X 1.6mm
Power supply	5V DC
Indicators	PWR，LED1，LED2
Communication Protocol	UART,IIC,SPI

Electrical Characteristics

Parameter	Min.	Typical	Max.	Unit
Power voltage	4.5	5	5.5	VDC
Input voltage VinH (Target Voltage = 3.3V)	3	3.3	3.6	V
Input voltage VinH (Target Voltage = 5V)	4.5	5	5.5	V
Input voltage VinL	-0.3	0	0.5	V
Current Consumption	-	40	-	mA

Hardware

Pin Map

Arduino Pin	Description
D0	XBEE_TX
D1	XBEE_RX
D2	nRF24L01_IRQ & STD Button
D3	IR_TX*
D4	SD_CS
D5	IR_RX*
D6	LED1*
D7	LED2*
D8	-
D9	nRF24L01_CE
D10	nRF24L01_CS
D11	MOSI
D12	MISO
D13	SCK
A0	A0 Button
A1	-
A2	-
A3	-
A4	SHT10_SDA
A5	SHT10_SCL

• IR_TX: when D3 is set as high level switch, IR Diode will emit signals out. When D3 is set as low level switch, IR Diode won’t work.
• IR_RX: Use HS0038B as IR receiving module
• Jumpers:

Jumpers can directly connect to Arduino’s IO. If you don’t need them or their corresponding pins are occupied, you can remove the jumpers.

• A0: insert a 10K resistance to A0 button
• LED1: connect to D6 pin. If the output voltage is high, LED1 turns on.
• LED2: connect to D7 pin. If the output voltage is high, LED1 turns on.

• Switch: Set the switch level according to Arduino main board. When the mainboard is set in 5V, you should turn the switch to 5V; when in 3.3V, you should turn to 3.3V.

Instruction

Please refer to our blogs:

http://blog.iteadstudio.com/diy-intelligent-monitor-for-home-temperature-and-humidity/

Download

• Schematic--File:IM140715001-IR Shield-schematic.pdf
• IR Receiver Datasheet--File:IM140715001-HS0038B.pdf
• SHT1x Datasheet--File:SHT1x_Datasheet.pdf
• Temperature & Humidity sensor demo--File:Sht10.zip

Useful Link

http://blog.iteadstudio.com/diy-intelligent-monitor-for-home-temperature-and-humidity/