HC06 Serial Bluetooth Brick

From ITEAD Wiki
Revision as of 08:10, 27 May 2014 by Ivy (Talk | contribs)

Jump to: navigation, search

Overview

Serial Bluetooth brick.jpg

What is an electronic brick? An electronic brick is an electronic module which can be assembled like Lego bricks simply by plugging in and pulling out. Compared to traditional universal boards and circuit modules assembled with various electronic components, electronic brick has standardized interfaces, plug and play, simplifying construction of prototype circuit on one’s own. There are many types of electronic bricks, and we provide more than twenty types with different functions including buttons, sensors, Bluetooth modules, etc, whose functions cover from sensor to motor drive, from Ethernet to wireless communication via Bluetooth, and so on. We will continue to add more types to meet the various needs of different projects.

Electronic brick of HC-06 serial port Bluetooth can be connected to hardware UART or analog UART on the control board. With Bluetooth communication, it can achieve wireless transmission which can be applied in various kinds of remote communication occasions.

Features

1. Plug and play, easy to use. Compatible with the mainstream 2.54 buckled interfaces in the market.

Serial Bluetooth brick1.jpg

2. With resetting button and status indicator

Serial Bluetooth brick2.jpg

Specifications

PCB Size 39.5mm X 20.5mm X 1.6mm
Working voltage 3.3V DC
Operating voltage 3.3V DC
Compatible interfaces 2.544-pin buckled interface(1)
Communication protocols Bluetooth 2.0
Communication range <20m

Note 1: DO for data output (TX) port of UART, DI for data input (RX) port of UART, V and G for voltage at the common collector and ground respectively.

Electrical Characteristics

Parameter Min. Typical Max. Unit
Working voltage 3 3.3 4.2 VDC
Digital output voltage(VCC=3.3V) 0 - 3.3 V
Working current(VCC=3.3V) - 20 40 mA

Switch and Indicator

1. Resetting button

After pressing down resetting button, module will re-enter standby mode and the status lamp will flash.

2. Status lamp

When the module is under standby mode, status lamp will keep flashing; when the module is under connection mode, status lamp will keep being ON.

AT Command

Default:

Slave,9600 bit/s baud rate, Pincode 1234.

AT command:

1. Communications test:

Sent: AT

Receive: OK

2. Change baud rate

Sent: AT+BAUD1

Receive: OK1200

Sent: AT+BAUD2

Receive: OK2400

1---------1200

2---------2400

3---------4800

4---------9600

5---------19200

6---------38400

7---------57600

8---------115200

Baud rate setting can be saved even if power is off.

3. Change name of Bluetooth device

Sent: AT+NAMEdevicename

Receive: OKname

(devicename is the name you want it to be, which will be shown when searched)

Name setting can be saved even if power is off.

4. Change Pincode

Sent: AT+PINxxxx

Receive: OKsetpin

(xxxx is the pin code that you want to set)

Pin code can be saved even if power is off.

Demo

Download

Useful Links