Difference between revisions of "128 X 64 OLED MODULE"

From ITEAD Wiki
Jump to: navigation, search
m (Overview)
m (Hardware)
Line 37: Line 37:
  
 
==Hardware==
 
==Hardware==
 +
 +
[[File:IM130625003pic1.png|500px]]
 +
 
http://imall.iteadstudio.com/media/wysiwyg/Products/Graphic_Display/IM130625003_1.jpg
 
http://imall.iteadstudio.com/media/wysiwyg/Products/Graphic_Display/IM130625003_1.jpg
  

Revision as of 02:23, 18 May 2015

Overview

128 X 64 OLED MODULE.jpg

OLED 2864 display module can work without backlight. In a dark environment, contrast of OLED display is higher compared to that of LCD display, and OLED is thinner and lighter. OLED 2864 is a monochrome graphic display module with built-in 0.96 inch, 128X64 high-resolution display. Driver chip of OLED module is SSD1306, which is compatible with IIC or SPI communication interface greatly reducing the IO port occupation. OLED module can be used in various commercial applications, such as display of mobile phones, portable digital media players, radio and digital cameras, and so.

Attention: This module can't be driven by 5V level mainboard in case it burns out.

Go shopping 128 X 64 OLED MODULE (IM130625003)

Specifications

PCB size 35.5mm X 35.5mm X 1.6mm
Working voltage 3.3V
Compatible interfaces IIC (default ) or SPI
IIC address 0x3C: D/C pin grounded; 0x3D: D/C pin connected to 3.3V

Electrical Characteristics

Specification Min Type Max Unit
Power Voltage 1.65 3.3 3.3 VDC
Working voltage (VCC=3.3V) 20 mA
Logic input voltage Vss-0.3 Vss+0.3 dB

Hardware

IM130625003pic1.png

IM130625003_1.jpg

Pin map

Pin Pin name Communication Description
1 VCC - Voltage at the common collector
2 GND - Ground
3 CS - Chip selection pin
4 RES - Reset pin
5 D/C - Data/command selection pin
6 SDA IIC Data input pin
6 SDIN SPI Data input pin
7 SCL IIC Data clock pin
7 SCLK SPI Data clock pin
8 NC - Not connected pin

Communication Interface Settings

OLED display module supports IIC or SPI communication with default as IIC. If you want to use SPI communication, following settings will be needed:

Remove resistors on R3, R4, R5, and R7, and weld a 0R resistor on R8.

Download

Datasheet for 128 X 64 OLED MODULE

Datasheet for SSD1306

MultiLCD library

SSD1306 Arduino Library

Useful Links