ITDB02-5.0
From ITEAD Wiki
Overview
ITDB02-5.0 display module is a 5.0" TFT LCD with 65K color 800 x 480 resolutions. The controller of this LCD module is SSD1963. It supports 16bit data interface with control interface of four wires. Moreover, this module contains the touch screen and SD card socket.
ITDB02-5.0 is supported by UTFT Library.
Go shopping ITDB02-5.0 (IM120419008)
Specifications
Driver IC | SSD1963 |
Backlight | |
Power supply | 3.3V |
Touch Panel | Y |
Touch IC | XPT2046 |
Resolution | 800*480 |
Size | 90mm*115mm |
Hardware
Pin Map
Pin | Type* | Description |
GND | G | Ground |
VCC | P | 5V Power Supply pin |
NC | - | No connection |
RS | I | Data/Command selection |
WR | I | Write signal enable, low active |
RD | I | Read signal enable, low active |
DB8 | I | Data Bus |
DB9 | I | Data Bus |
DB10 | I | Data Bus |
DB11 | I | Data Bus |
DB12 | I | Data Bus |
DB13 | I | Data Bus |
DB14 | I | Data Bus |
DB15 | I | Data Bus |
CS | I | Chip Selection,Low level active |
NC | - | No connection |
RST | I | Reset Pin |
NC | - | No connection |
LED | P | Backlight(3.3V) |
NC | - | No connection |
DB0 | I | Data Bus |
DB1 | I | Data Bus |
DB2 | I | Data Bus |
DB3 | I | Data Bus |
DB4 | I | Data Bus |
DB5 | I | Data Bus |
DB6 | I | Data Bus |
DB7 | I | Data Bus |
T_CLK | I | Touch clock |
T_CS | I | Touch chip selection |
T_DIN | I | Touch data input |
T_BUSY | O | Touch status |
T_DOUT | O | Touch data output |
T_IRQ | O | Touch interrupt |
SD_SO | O | SD MISO |
SD_SCK | I | SD SCK |
SD_SI | I | SD MOSI |
SD_NSS | I | SD NSS |
NC | - | No connection |
NC | - | No connection |
Download
Schematic--File:IM120419008-ITDB02-5_0-schematic.pdf