Arduino 3.2 TFT LCD Touch Shield V2

Overview

Arduino 3.2" TFT LCD Touch shield V2 is an Arduino Mega compatible multicolored TFT display with touch-screen and SD card socket. It is available in an Arduino MEGA shield compatible pinout for attachment. The TFT driver is based on ILI9341 with 8bit data and 4bit control interface.

The Arduino 3.2" TFT LCD Touch shield V2 can work with both 3.3V and 5V, so it can dispaly on Chipkit MAX32 as well.

NOTE: this screen adopts new chip, thus the old library is not applicable. Please use the New UTFT Library.

Go shopping [3.2 TFT LCD Touch Shield V2(IM160418006) Coming Soon!!!]

Features

• Arduino Mega Shield compatible footprint
• Arduino new UTFT library support
• TFTResolution : 240 x 320 pixels
• Size : 3.2"
• Colors : 65K
• Backlight : LED
• Driver IC: ILI9341

Specifications

PCB size	79.3mm X 57.5mm X 1.6mm
Indicators	-
Power supply	compatible with Arduino Mega
Communication Protocol	-
RoHS	Yes

Electrical Characteristics

Specification	Min	Type	Max	Unit
Power Voltage	4.5	5	5.5	VDC
Input Voltage VH:	3	-	5.5	V
Input Voltage VL:	-0.3	0	0.5	V

Hardware

Figure 1 Bottom View

Pin map of Arduino 3.2” TFT Touch Shield V2:

Arduino Mega PIN	Description
D2	T_IRQ
D3	T_DOUT
D4	T_DIN
D5	T_CS
D6	T_CLK
D22	DB8
D23	DB9
D24	DB10
D25	DB11
D26	DB12
D27	DB13
D28	DB14
D29	DB15
D30	DB7
D31	DB6
D32	DB5
D33	DB4
D34	DB3
D35	DB2
D36	DB1
D37	DB0
D38	RS
D39	WR
D40	CS
D41	RST
D50	SD_MISO
D51	SD_MOSI
D52	SD_SCK
D53	SD_NSS

The Arduino 3.2” Touch shield V2 uses the ILI9341 controller , it support 16bit data interface. The touch IC is XPT2046.

Operation voltage level setting switch

When using the Arduino 3.2 TFT Touch shield V2 with 5V operation level development board – like Arduino MEGA and so on, set the operation voltage level switch to 5V side.

When using the Arduino 3.2 TFT Touch shield V2 with 3.3V operation level development board set the operation voltage level switch to 3.3V side.

Download

Demo code

Schematic

New UTFT Library