RASPBERRY PI GPS ADD-ON

Overview

Raspberry PI GPS Add-on is customized for Raspberry Pi interface based on NEO-6 GPS module. Through the serial port on Raspberry Pi, data returned from NEO-6 module can be received, thus information such as the current location and time can be searched.

Go shopping RASPBERRY PI GPS ADD-ON (IM131227001)

Specifications

PCB size	58.5mm X 54.6mm X 1.6mm
Input voltage	3.3V
Interface	UART
Baud rate	38400 (default)

Electrical characteristics

Parameters	Min.	Typical	Max.	Unit
Supply voltage	-	3.3	3.6	VDC
Current consumption (average)	-	40	-	mA

Hardware

Pinmap

Raspberry PI interfaces

Raspberry PI Pin N.O.	Pin name	Pin of GPS Module	Description
11	GPIO0	-	Electronic brick interface
12	GPIO1	-	Electronic brick interface
13	GPIO2	-	Electronic brick interface
15	GPIO3	-	Electronic brick interface
16	GPIO4	-	Electronic brick interface
18	GPIO5	-	Electronic brick interface
22	GPIO6	1PPS	Pulse per second / Electronic brick interface
7	GPIO7	EXINT	External interruption pin / Electronic brick interface
3	SDA0	-	Electronic brick interface
5	SCL0	-	Electronic brick interface
24	CE0	CS	Chip selection for Micro SD card
26	CE1	-	Electronic brick interface
19	MOSI	MOSI	Data input for Micro SD card
21	MISO	MISO	Data output for Micro SD card
23	SCLK	SCLK	Clock for Micro SD card
8	TXD	GPS_RX	Receiving end for SIM900 serial port
10	RXD	GPS_TX	Sending end for SIM900 serial port
2	+5V	-
1	+3.3V	-
6	GND	-

Indicator

• PWR

Power: When there is normal supply to the board, the power indicator keeps on.

Download

Datasheet for RASPBERRY PI GPS ADD-ON

Schematic for RASPBERRY PI GPS ADD-ON

Useful Links

• Raspberry Pi + ITead Studio GPS by mcauser

This is a tutorial demonstrated how to use ITEAD RPI GPS Add-on with Raspberry Pi.