ITDB02-2.4E
Overview
ITDB02-2.4E module is 2.4" TFT LCD with 65K color 320 x 240 resolutions. The controller of this LCD module is ILI9325D, it supports 8bit / 16bit data interface with 4 wires control interface. Moreover, this module includes the touch screen and SD card socket.
Go shopping ITDB02-2.4E (IM120419004)
Features
- Compatible with 3.3/5V operation voltage level
- 8bits/16bits operation compatible
- Compatible with UTFT library
- With SD Card Socket
Specifications
Driver IC | ILI9325D |
Backlight | 4LEDs |
Power supply | 3V3 |
Touch Panel | Y |
Touch IC | XPT2046 |
Resolution | 240*320 |
Size | 50mm*65mm |
Hardware
Pin Map list
Pin | Type* | Description |
GND | G | Ground |
VCC | P | 5V Power Supply pin |
NC | - | No connection |
RS | I | Data/Command selection |
WR | I | Write signal enable, low active |
RD | I | Read signal enable, low active |
DB8 | I | Data Bus |
DB9 | I | Data Bus |
DB10 | I | Data Bus |
DB11 | I | Data Bus |
DB12 | I | Data Bus |
DB13 | I | Data Bus |
DB14 | I | Data Bus |
DB15 | I | Data Bus |
CS | I | Chip Selection,Low level active |
NC | - | No connection |
LED | P | Backlight |
NC | - | No connection |
DB0 | - | No connection(8bit mode) |
DB0 | I | Data Bus(16bit mode) |
DB1 | - | No connection(8bit mode) |
DB1 | I | Data Bus(16bit mode) |
DB2 | - | No connection(8bit mode) |
DB2 | I | Data Bus(16bit mode) |
DB3 | - | No connection(8bit mode) |
DB3 | I | Data Bus(16bit mode) |
DB4 | - | No connection(8bit mode) |
DB4 | I | Data Bus(16bit mode) |
DB5 | - | No connection(8bit mode) |
DB5 | I | Data Bus(16bit mode) |
DB6 | - | No connection(8bit mode) |
DB6 | I | Data Bus(16bit mode) |
DB7 | - | No connection(8bit mode) |
DB7 | I | Data Bus(16bit mode) |
T_CLK | I | Touch clock |
T_CS | I | Touch chip selection |
T_DIN | I | Touch data input |
T_BUSY | O | Touch status |
T_DOUT | O | Touch data output |
T_IRQ | O | Touch interrupt |
SD_SO | O | SD MISO |
SD_SCK | I | SD SCK |
SD_SI | I | SD MOSI |
SD_NSS | I | SD NSS |
NC | - | No connection |
NC | - | No connection |
Type *:P: Power supply; G:Ground; I:Input; O:Output;
The ITDB02_2.4E uses the S6D1121 controller , it support 8/16bit data interface. The touch IC is TSC2046.
Installation
When operate in 8 bits mode, the mode switch need to set in 8bits side.
When operate in 16 bits mode, the mode switch need to set in 16bits side.