ITDB06

From ITEAD Wiki
Revision as of 07:54, 16 March 2016 by ITead (Talk | contribs)

Jump to: navigation, search

Overview

The ITDB06 WiFi Module is a low-cost universal WiFi module that developed and designed by ITEAD. The module integrates industry leading Tensilica L106 ultra-low power 32-bit MCU, 16-bit compact mode, frequency supports 80MHz and 160MHz, supports RTOS, integrates Wi-Fi MAC/ BB/RF/PA/LNA, on-board antenna.

This module supports standard IEEE802.11 b/g/n protocol and complete TCP/IP protocol stack.. It allows users to add Internet of Things (IoT) to devices or to build a separate network controller.

ITDB06 is high performance wireless SOC, it provides maximum usability at the lowest cost, offering unlimited possibilities for adding WiFi functions to other systems.

ITDB06 Blocks.jpg

ITDB06 is a complete and self-contained WiFi network solution that can run independently, it can also be mounted as a slave host MCU operation.

When the module is mounted to application and as the only processor, it can boot directly from the external flash memory. Built-in cache system is provided to increase system performance and reduce memory requirements.

When the wireless network is accessed and undertake WiFi adapter tasks, you can add it to any microcontroller-based design, simply connect SPI/SDIO interface or I2C/UART interface.

The powerful processing and storage capabilities enable it to integrate sensors and other application-specific devices through GPIO, which achieves lowest pre-development and minimal system resources occupation during performing.

This module integrates antenna switch balun and power management converter, thus little external circuitry needed, and the entire solution including the front-end module has reduced the PCB size to a new minimum.

The ITDB06 system leading features include energy saving VoIP quickly switch between sleep/ wake mode, low-power operation self-adaptive radio bias, front-end signal processing capability, troubleshooting and radio systems coexist performance eliminates interference of cellular/Bluetooth/DDR/LVDS/LCD .

Features

  • 802.11 b/g/n
  • WIFI @2.4 GHz,support WPA/WPA2 safe mode
  • Small size 11.5mm*11.5mm
  • Built-in 10 bit high accuracy ADC
  • Built-in TCP/IP protocol stack
  • Built-in switch, balun, LNA, power amplifier and matching network
  • Built-in PLL, voltage stabilizer and power management components
  • 802.11b mode + 20 dBm output power
  • Support antenna diversity
  • 10uA deep sleep maintain current, shutdown current is less than 5 uA
  • Built-in 32-bit lower power CUP
  • SDIO 2.0、SPI、UART
  • STBC、1x1 MIMO、2x1 MIMO
  • A-MPDU&A-MSDU aggregation and 0.4us guard interval
  • Wake-up, connect and transfer data packets in 2 ms
  • Standby power consumption: <1.0mW (DTIM3)
  • Temp range:-40 ~ 125℃

Specification

Electrical Characteristics

Hardware

PIN MAP

Download

Useful link