Difference between revisions of "ITDB06"
m (→Specification) |
m (→Specification) |
||
Line 71: | Line 71: | ||
| Storage temperature || Room temperature | | Storage temperature || Room temperature | ||
|- | |- | ||
− | | Size || | + | | Size || 16mm*24mm*3mm |
|- | |- | ||
| rowspan=6 |Software parameters || Wireless Network Mode || Station/softAP/SoftAP+station | | rowspan=6 |Software parameters || Wireless Network Mode || Station/softAP/SoftAP+station |
Revision as of 08:30, 16 March 2016
Contents
Overview
The ITDB06 WiFi Module is a low-cost universal WiFi module that developed and designed by ITEAD. The module integrates industry leading Tensilica L106 ultra-low power 32-bit MCU, 16-bit compact mode, frequency supports 80MHz and 160MHz, supports RTOS, integrates Wi-Fi MAC/ BB/RF/PA/LNA, on-board antenna.
This module supports standard IEEE802.11 b/g/n protocol and complete TCP/IP protocol stack.. It allows users to add Internet of Things (IoT) to devices or to build a separate network controller.
ITDB06 is high performance wireless SOC, it provides maximum usability at the lowest cost, offering unlimited possibilities for adding WiFi functions to other systems.
ITDB06 is a complete and self-contained WiFi network solution that can run independently, it can also be mounted as a slave host MCU operation.
When the module is mounted to application and as the only processor, it can boot directly from the external flash memory. Built-in cache system is provided to increase system performance and reduce memory requirements.
When the wireless network is accessed and undertake WiFi adapter tasks, you can add it to any microcontroller-based design, simply connect SPI/SDIO interface or I2C/UART interface.
The powerful processing and storage capabilities enable it to integrate sensors and other application-specific devices through GPIO, which achieves lowest pre-development and minimal system resources occupation during performing.
This module integrates antenna switch balun and power management converter, thus little external circuitry needed, and the entire solution including the front-end module has reduced the PCB size to a new minimum.
The ITDB06 system leading features include energy saving VoIP quickly switch between sleep/ wake mode, low-power operation self-adaptive radio bias, front-end signal processing capability, troubleshooting and radio systems coexist performance eliminates interference of cellular/Bluetooth/DDR/LVDS/LCD .
Features
- 802.11 b/g/n
- WIFI @2.4 GHz,support WPA/WPA2 safe mode
- Small size 11.5mm*11.5mm
- Built-in 10 bit high accuracy ADC
- Built-in TCP/IP protocol stack
- Built-in switch, balun, LNA, power amplifier and matching network
- Built-in PLL, voltage stabilizer and power management components
- 802.11b mode + 20 dBm output power
- Support antenna diversity
- 10uA deep sleep maintain current, shutdown current is less than 5 uA
- Built-in 32-bit lower power CUP
- SDIO 2.0、SPI、UART
- STBC、1x1 MIMO、2x1 MIMO
- A-MPDU&A-MSDU aggregation and 0.4us guard interval
- Wake-up, connect and transfer data packets in 2 ms
- Standby power consumption: <1.0mW (DTIM3)
- Temp range:-40 ~ 125℃
Specification
Category | Parameters | Explanation |
---|---|---|
Radio parameters | Wireless Standard | 802.11 b/g/n |
Frequency Range | 2.4G-25G(2400M-2483.5M) | |
Transmitting power | 802.11b: 20dBm | |
802.11g: 17dBm | ||
802.11n: 14dBm | ||
Receiving sensitivity | 802.11b: (11Mbps)-91dbm | |
802.11g: (54Mbps)-75dbm | ||
802.11n: (MCS7)-72dbm | ||
Hardware parameters | Data access | UART/HSPI/I2C/I2S/Ir Remote Control |
GPIO/PWM | ||
Operating Voltage | 3.0~3.6V(Suggested 3.3V) | |
Working current | Average: 80mA | |
Operating temperature | -40°~125° | |
Storage temperature | Room temperature | |
Size | 16mm*24mm*3mm | |
Software parameters | Wireless Network Mode | Station/softAP/SoftAP+station |
Security Mechanism | WPA/WPA2 | |
Encryption Type | WEP/TKIP/AES | |
Upgrading firmware | Local serial programming / Cloud Upgrade / Host Download Burn | |
Network protocol | IPv4, TCP/UDP/HTTP/FTP | |
User Profiles | AT + instruction set, cloud server, Android/iOS APP |