Difference between revisions of "RASPBERRY PI Arduino Shield ADD-ON"

Revision as of 08:15, 17 July 2014

Overview

Compared to Arduino, it's hard to find the shields and electronic brick customized for Raspberry Pi. This Arduino Shield Add-on has extended RPI 32PIN Connector to Arduino PIN, which will facilitate connections to all kinds of arduino shields. Meanwhile, two groups of electronic brick interfaces are equipped on the add-on, which are free to be connected to various electronic bricks.

We do not only offer this convenient add-on for Raspberry Pi, but also provide an SDK that help you transplant divers of Arduino into Raspberry Pi. After installing the SDK, you can drive this add-on as easily as you do on Arduino.

Features

• • extend RPI 32pin connector to Arduino Shield
• two groups of Grove electronic brick interfaces
• two electronic brick intefaces
• two optional voltage levels 3V3/5V

Specification

Electrical Characteristics

Hardware

Pin Map

Instruction

• Plug Rpi Arduino Shield Add-on into RPI V2, connect SHT10 to IIC interface through 4-pin wires. Power Raspberry Pi V2.
• Download the SDK from this link: https://github.com/iteadsw/SDK and then install it.
• Modify the file ReadSHT1xValues.ino

modified codes as below:

define dataPin 3

define clockPin 5

• Enter into the directory libraries/itead_SHT1x/examples/ReadSHT1xValues, compile and run the file ReadSHT1xValues.ino

Command as below to compile ReadSHT1xValues.ino

$ iteadcompile ReadSHT1xValues ReadSHT1xValues.ino

Command to run this program

$ sudo ./ ReadSHT1xValues

• When the compilation is done, you can read the temperature and humidity data from the terminal.

Download

File:SHC IM140714004.pdf

Useful Link

https://github.com/iteadsw/SDK