NoticeDifference between revisions of "Iteaduino Leonardo"
(→Overview) |
|||
| Line 12: | Line 12: | ||
* UART/IIC interface breakout | * UART/IIC interface breakout | ||
* All electronic brick socket are broken out | * All electronic brick socket are broken out | ||
| − | |||
| − | |||
| − | |||
==Spec== | ==Spec== | ||
| Line 45: | Line 42: | ||
| Yes | | Yes | ||
|} | |} | ||
| + | |||
| + | ==Electrical Characteristics== | ||
| + | |||
| + | ==Hardware== | ||
| + | [[File:Iteaduino Leonardo.jpg]] | ||
| + | |||
| + | Digital/Servo Interface: D0~D13 pin | ||
| + | |||
| + | Sensor Interface: A0 A1 A2 A3 A4 A5 pin | ||
| + | |||
| + | ==Pin Map== | ||
| + | |||
| + | ==Power Supply== | ||
| + | |||
| + | ==Memory== | ||
| + | |||
| + | ==Input and Output== | ||
| + | |||
| + | ==Communication== | ||
| + | |||
| + | ==Programming== | ||
| + | |||
| + | ==Automatic (Software) Reset and Bootloader== | ||
| + | |||
| + | ===Initiation=== | ||
| + | |||
| + | ===USB Over-current Protection=== | ||
| + | |||
| + | ===Physical Characteristics=== | ||
==Download== | ==Download== | ||
Revision as of 06:29, 20 May 2014
Contents
Overview
Iteaduino Leonardo is a microcontroller board based on the ATmega32u4, it's 100% campatible with Arduino Leonardo. It has 20 digital input/output pins, a 16 MHz crystal oscillator, a micro USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with an AC-to-DC adapter or battery to get started.
Iteaduino Leonardo differs from all preceding boards in that the ATmega32u4 has built-in USB communication, eliminating the need for a secondary processor. This allows the Leonardo to appear to a connected computer as a mouse and keyboard, in addition to a virtual (CDC) serial / COM port. It also has other implications for the behavior of the board.
Features
- Efficient DC-DC Power supply with wide range input.
- 3.3V/5V Operating Voltage selection
- All pins out for Sensor and Servo
- UART/IIC interface breakout
- All electronic brick socket are broken out
Spec
| Microprocessor | ATmega32U4 |
| PCB Size | 68.58mm X 58.42mm X 1.6mm |
| Indicators | Power,TX,RX,L |
| Power supply(recommended) | 7-23V DC |
| Power supply(limits) | 23 VDC(max) |
| Communication Protocol | UART,SPI,IIC |
| Clock Speed | 16MHz |
| RoHS | Yes |
Electrical Characteristics
Hardware
Digital/Servo Interface: D0~D13 pin
Sensor Interface: A0 A1 A2 A3 A4 A5 pin
Pin Map
Power Supply
Memory
Input and Output
Communication
Programming
Automatic (Software) Reset and Bootloader
Initiation
USB Over-current Protection
Physical Characteristics
Download
Datasheet for Iteaduino Leonardo
Schematic for Iteaduino Leonardo
Fritzing Parts for Iteaduino Leonardo
