NoticeDifference between revisions of "Iteaduino UNO"
From ITEAD Wiki
(→Features) |
(→Spec) |
||
| Line 17: | Line 17: | ||
==Spec== | ==Spec== | ||
| − | + | {| border="1" | |
| − | + | ||
| − | + | |- | |
| − | + | | Microprocessor | |
| − | + | | ATmega328,ATmega8U2 | |
| − | + | |- | |
| − | + | | PCB size | |
| + | | 68.58mm X 58.42mm X 1.6mm | ||
| + | |- | ||
| + | | Indicators | ||
| + | | Power,TX,RX,D13 | ||
| + | |- | ||
| + | | Power supply(recommended) | ||
| + | | 7-23V DC | ||
| + | |- | ||
| + | | Power supply(limits) | ||
| + | | 23 VDC (max) | ||
| + | |- | ||
| + | | Communication Protocol | ||
| + | | UART,SPI,IIC | ||
| + | |- | ||
| + | | Clock Speed | ||
| + | | 16MHz | ||
| + | |} | ||
==Download== | ==Download== | ||
Revision as of 07:32, 19 May 2014
Overview
Iteaduino Uno is a microcontroller board based on the Arduino UNO. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with an AC-to-DC adapter or battery to get started.
Features
- New external IO pin map
- Efficient DC-DC Power supply with wide range input
- 3.3V/5V Operating Voltage selection
- All pins out for Sensor and Servo
- UART/IIC interface breakout
Hardware
Spec
| Microprocessor | ATmega328,ATmega8U2 |
| PCB size | 68.58mm X 58.42mm X 1.6mm |
| Indicators | Power,TX,RX,D13 |
| Power supply(recommended) | 7-23V DC |
| Power supply(limits) | 23 VDC (max) |
| Communication Protocol | UART,SPI,IIC |
| Clock Speed | 16MHz |
Download
Fritzing Parts for Iteaduino UNO
