NoticeDifference between revisions of "Serial Port Bluetooth Module (Master/Slave) : HC-05"
From ITEAD Wiki
(→Hardware Features) |
(→Software Features) |
||
| Line 22: | Line 22: | ||
===Software Features=== | ===Software Features=== | ||
| + | * Default Baud rate: 38400, Data bits:8, Stop bit:1,Parity:No parity, Data control: has. | ||
| + | Supported baud rate: 9600,19200,38400,57600,115200,230400,460800. | ||
| + | * Given a rising pulse in PIO0, device will be disconnected. | ||
| + | * Status instruction port PIO1: low-disconnected, high-connected; | ||
| + | * PIO10 and PIO11 can be connected to red and blue led separately. When master and slave | ||
| + | are paired, red and blue led blinks 1time/2s in interval, while disconnected only blue led | ||
| + | blinks 2times/s. | ||
| + | * Auto-connect to the last device on power as default. | ||
| + | * Permit pairing device to connect as default. | ||
| + | * Auto-pairing PINCODE:”0000” as default | ||
| + | * Auto-reconnect in 30 min when disconnected as a result of beyond the range of connection. | ||
==Hardware== | ==Hardware== | ||
Revision as of 09:04, 28 May 2014
Contents
Overview
HC-05 module is an easy to use Bluetooth SPP (Serial Port Protocol) module, designed for transparent wireless serial connection setup.
Serial port Bluetooth module is fully qualified Bluetooth V2.0+EDR (Enhanced Data Rate) 3Mbps Modulation with complete 2.4GHz radio transceiver and baseband. It uses CSR Bluecore 04-External single chip Bluetooth system with CMOS technology and with AFH(Adaptive Frequency Hopping Feature). It has the footprint as small as 12.7mmx27mm. Hope it will simplify your overall design/development cycle.
Specifications
Hardware Features
- Typical -80dBm sensitivity
- Up to +4dBm RF transmit power
- Low Power 1.8V Operation ,1.8 to 3.6V I/O
- PIO control
- UART interface with programmable baud rate
- With integrated antenna
- With edge connector
Software Features
- Default Baud rate: 38400, Data bits:8, Stop bit:1,Parity:No parity, Data control: has.
Supported baud rate: 9600,19200,38400,57600,115200,230400,460800.
- Given a rising pulse in PIO0, device will be disconnected.
- Status instruction port PIO1: low-disconnected, high-connected;
- PIO10 and PIO11 can be connected to red and blue led separately. When master and slave
are paired, red and blue led blinks 1time/2s in interval, while disconnected only blue led blinks 2times/s.
- Auto-connect to the last device on power as default.
- Permit pairing device to connect as default.
- Auto-pairing PINCODE:”0000” as default
- Auto-reconnect in 30 min when disconnected as a result of beyond the range of connection.
