NoticeDifference between revisions of "WIFI SHIELD REV2"
From ITEAD Wiki
(Created page with "==Overview== ==Specifications== ==Electrical Characteristics== ==Hardware== ==Pinmap== ==UART Multiplexer== ==Switch of operation level== ==Switch for transparent trans...") |
(→Overview) |
||
| Line 1: | Line 1: | ||
==Overview== | ==Overview== | ||
| + | [[File:WIFI Shield REV2 .jpg|thumb|400px|right]] | ||
| + | |||
| + | WIFI [[Shield]] REV2 supports IEEE 802.11b/g/n wireless protocol standard and serial output, which integrates TCP / IP protocol stack internally. It is specifically designed for Arduino boards including Arduino UNO, MEGA and Leonardo, and it supports 3.3V or 5V operation level so it can work with more Arduino-compatible boards. | ||
==Specifications== | ==Specifications== | ||
Revision as of 08:32, 26 May 2014
Contents
Overview
WIFI Shield REV2 supports IEEE 802.11b/g/n wireless protocol standard and serial output, which integrates TCP / IP protocol stack internally. It is specifically designed for Arduino boards including Arduino UNO, MEGA and Leonardo, and it supports 3.3V or 5V operation level so it can work with more Arduino-compatible boards.
Specifications
Electrical Characteristics
Hardware
Pinmap
UART Multiplexer
Switch of operation level
Switch for transparent transmission
Indicator
- PWR, 3.3V supply indicator: when supply is normal, PWR indicator will keep ON.
Button
- WIFI_RST, WIFI resetting button: press the button to reset WIFI module.
Note
- There is no existing library to support the module at present.
