NoticeDifference between revisions of "Arduino GPS shield"
From ITEAD Wiki
(→Features) |
(→Specifications) |
||
| Line 17: | Line 17: | ||
==Specifications== | ==Specifications== | ||
| + | {| border="1" | ||
| + | |||
| + | | PCB size||55.88mm X 54.1mm X 1.6mm | ||
| + | |- | ||
| + | | Indicators ||PWR | ||
| + | |- | ||
| + | | Power supply||compatible with Arduino | ||
| + | |- | ||
| + | | Communication Protocol||UART | ||
| + | |- | ||
| + | | RoSH||Yes | ||
| + | |} | ||
==Electrical Characteristics== | ==Electrical Characteristics== | ||
Revision as of 06:16, 23 May 2014
Contents
Overview
Arduino GPS shield is a GPS module breadout board designed for Global Positioning System receiver with SD interface. It is easy to use for recording the position data into SD card. 5V/3.3V compatible operation voltage level make it compatible with Arduino boards, leaf maple, IFlat32 and other arduino compatible boards.
Features
- With Micro SD interface
- Active antenna design with high receive sensitivity, compatible
normal antenna
- Extremely fast time to first fix at low signal level
- UART interface
- Operation temperature: -40℃ ~ +85℃
Specifications
| PCB size | 55.88mm X 54.1mm X 1.6mm |
| Indicators | PWR |
| Power supply | compatible with Arduino |
| Communication Protocol | UART |
| RoSH | Yes |
