NoticeDifference between revisions of "Iteaduino BT"
From ITEAD Wiki
(→Overview) |
|||
| Line 14: | Line 14: | ||
* 3.3V/5V Operating Voltage selection | * 3.3V/5V Operating Voltage selection | ||
| − | |||
| − | |||
| − | |||
==Spec== | ==Spec== | ||
| Line 47: | Line 44: | ||
| Yes | | Yes | ||
|} | |} | ||
| + | |||
| + | ==Electrical Characteristic== | ||
| + | |||
| + | ==Hardware== | ||
| + | [[File:IteaduinoBT1.jpg]] | ||
| + | |||
| + | Digital/Servo Interface: D0~D13 pin | ||
| + | |||
| + | Sensor Interface: A0 A1 A2 A3 A4 A5 pin | ||
| + | |||
| + | ==HC-05 operate mode set switch== | ||
| + | |||
| + | ==Communicate mode set jumper == | ||
==Download== | ==Download== | ||
Revision as of 05:33, 20 May 2014
Contents
Overview
Iteaduino-BT is an Arduino compatible board with a master/slave Bluetooth Module HC-05. It based on Arduino UNO/Duemilanove, 100% compatible with its existing program and shields, but with the bluetooth wireless funcion. The power consumption is about 50% of the original Arduino boards.
Features
- Design for Bluetooth communication
- Compatible with Arduino UNO/Duemilanove pins, holes and dimensions
- Wide range external input from 7~23V DC
- Pins out for Sensor and Servo
- 3.3V/5V Operating Voltage selection
Spec
| Microcontroller | ATMega328P |
| PCB size | 10mm X 82mm X 1.6mm |
| Indicators | Power,TX,RX,D13,LED1,LED2 |
| Power supply(recommended) | 7-23V DC |
| Power supply(limits) | 23 VDC (max) |
| Communication Protocol | UART,SPI,IIC |
| Clock Speed | 16MHz |
| RoHS | Yes |
Electrical Characteristic
Hardware
Digital/Servo Interface: D0~D13 pin
Sensor Interface: A0 A1 A2 A3 A4 A5 pin
HC-05 operate mode set switch
Communicate mode set jumper
Download
Demo Code for Iteaduino BT Master Mode
Fritzing Parts for Iteaduino BT
Useful Link
<Correct Iteaduino BT Datasheet>
By Michael Doherty <Iteaduino BT Test Vedio>
By Benjamin Bellamy <How-To configure and use an Iteaduino BT>
