NoticeDifference between revisions of "Iteaduino Nano"
From ITEAD Wiki
(→Hardware) |
(→Spec) |
||
| Line 6: | Line 6: | ||
==Spec== | ==Spec== | ||
| + | {| border="1" | ||
| + | |||
| + | |- | ||
| + | | Microcontroller | ||
| + | | Atmega328 | ||
| + | |||
| + | |- | ||
| + | | Operating Voltage | ||
| + | | 5V | ||
| + | |- | ||
| + | | POWER Supply Voltage(recommended) | ||
| + | | 7~12V | ||
| + | |- | ||
| + | | Power supply Max Voltage | ||
| + | | 12V | ||
| + | |- | ||
| + | | Digital IO pins | ||
| + | | 20 | ||
| + | |- | ||
| + | | Analog Input pins(ADC) | ||
| + | | 8 | ||
| + | |- | ||
| + | | DC Output current on per IO lines | ||
| + | | 40mA | ||
| + | |- | ||
| + | | Flash Memory | ||
| + | | 32 KB of which 2 KB used by boot loader | ||
| + | |- | ||
| + | | SRAM | ||
| + | | 2 KB | ||
| + | |- | ||
| + | | EEPROM | ||
| + | | 1KB | ||
| + | |- | ||
| + | | Clock frequency | ||
| + | | 16 MHz | ||
| + | |- | ||
| + | | Dimension | ||
| + | | 43.18X17.78X1.6mm | ||
| + | |} | ||
==Download== | ==Download== | ||
==Useful Link== | ==Useful Link== | ||
Revision as of 07:58, 19 May 2014
Contents
Overview
Iteaduino Nano is a small, complete, and breadboard-friendly board based on the Arduino Nano 3.0. It has more or less the same functionality of the Arduino Duemilanove, but in a different package. It lacks only a DC power jack, and works with a Micro USB cable instead of a standard one.
Hardware
Spec
| Microcontroller | Atmega328 |
| Operating Voltage | 5V |
| POWER Supply Voltage(recommended) | 7~12V |
| Power supply Max Voltage | 12V |
| Digital IO pins | 20 |
| Analog Input pins(ADC) | 8 |
| DC Output current on per IO lines | 40mA |
| Flash Memory | 32 KB of which 2 KB used by boot loader |
| SRAM | 2 KB |
| EEPROM | 1KB |
| Clock frequency | 16 MHz |
| Dimension | 43.18X17.78X1.6mm |
