NoticeDifference between revisions of "Low-cost Digital Compass Module"
(→Overview) |
(→Specifications) |
||
| Line 10: | Line 10: | ||
==Specifications== | ==Specifications== | ||
| + | {| border="1" | ||
| + | |||
| + | | Measuring range||0-360 ° | ||
| + | |- | ||
| + | | Resolution||0.1 | ||
| + | |- | ||
| + | | Accuracy||1° | ||
| + | |- | ||
| + | | Power supply||3V-5V DC | ||
| + | |- | ||
| + | | Frequency response||25Hz | ||
| + | |- | ||
| + | | Current||5 V--15mA 3V--8 mA | ||
| + | |- | ||
| + | | Size||25.6mm×25.6mm | ||
| + | |} | ||
==Hardware == | ==Hardware == | ||
Revision as of 09:13, 29 May 2014
Contents
Overview
This is a low cost digital compass with UART and IIC interface, it's easy to use with external controler like Arduino,IFLAT32.
Features
- Small size
- Uart or IIC doulbe output/control interface
- 3-5V Voltage comaptible
Specifications
| Measuring range | 0-360 ° |
| Resolution | 0.1 |
| Accuracy | 1° |
| Power supply | 3V-5V DC |
| Frequency response | 25Hz |
| Current | 5 V--15mA 3V--8 mA |
| Size | 25.6mm×25.6mm |
Hardware
Serial Communication Protocol
Baud rate: 9600 bps Parity: N data bits: 8 Stop bit: 1
Command
0x31: the first angle measurement 0xC0: calibration of the magnetic field start 0xC1: the end of the calibration magnetic field 0xA0-0XAA-0XA5-0XC5: Restore default setting 0xA0-0XAA-0XA5-IIC_ADDR: IIC address of the module change 0x03 + 8bit: Setting the magnetic declination high 8 bit 0x04 + 8bit: Setting the magnetic declination low8 bit Return Data
Byte0: 0x0D Byte1: 0x0A Byte2: 0x30 ~ 0x33 angle of one hundred (ASCII 0 ~ 3) Byte3: 0x30 ~ 0x39 angle of ten (ASCII 0 ~ 9) Byte4: 0x30 ~ 0x39 angle a bit (ASCII 0 ~ 9) Byte5: 0x2E (ASCII code decimal point) Byte6: 0x30 ~ 0x39 decimal point (ASCII 0 ~ 9) Byte7: 0x00 ~ 0xFF checksum (only lower 8bit) You can use the Foca or USBtoTLL moudle to connect your PC with this moudle.
