NoticeDifference between revisions of "Touch Sensor/Button Brick"
From ITEAD Wiki
(→Features) |
(→Specifications) |
||
| Line 12: | Line 12: | ||
==Specifications== | ==Specifications== | ||
| + | {| border="1" | ||
| + | |||
| + | | PCBsize||38.0mmX24.0mmX1.6mm | ||
| + | |- | ||
| + | | Workingvoltage||3.3or5VDC | ||
| + | |- | ||
| + | | Operatingvoltage||3.3or5VDC | ||
| + | |- | ||
| + | | Compatibleinterfaces||2.543-pininterfaceand4-pinGroveinterface (1) | ||
| + | |} | ||
| + | |||
| + | ''Note 1： S for digital output port, N for not used pin, V and G for voltage at the common collector and ground respectively. When there is no operation, digital output is VDD; when the button is pressed down, the digital output is 0V.'' | ||
==Electrical Characteristics== | ==Electrical Characteristics== | ||
Revision as of 07:00, 27 May 2014
Contents
Overview
Electronic brick of touch button switch is finger-sized, which can be connected to I/O port of main board or externally disconnected to check the switch state so as to control ON/OFF of LED lamp.
Features
1. Plug and play, easy to use. Compatible with the mainstream 2.54 interfaces and 4-Pin Grove interfaces in the market.
2. With use of M4 standard fixed holes, compatible with M4-standard kits such as Lego and Makeblock.
Specifications
| PCBsize | 38.0mmX24.0mmX1.6mm |
| Workingvoltage | 3.3or5VDC |
| Operatingvoltage | 3.3or5VDC |
| Compatibleinterfaces | 2.543-pininterfaceand4-pinGroveinterface (1) |
Note 1： S for digital output port, N for not used pin, V and G for voltage at the common collector and ground respectively. When there is no operation, digital output is VDD; when the button is pressed down, the digital output is 0V.
